Precautions for installing stainless steel screen

Precautions for installing stainless steel screen

When the stainless steel screen is installed on the bottom of the completed bottom screen, it should be fixed on the bottom stainless steel screen along the lower frame of the newly installed stainless steel screen with a binding wire. The adjacent stainless steel screens on the same layer should also be tied to each other with binding wires. Connect the stainless steel screen into a whole;

When constructing at the same level of a certain unit project, the stainless steel screen should be fully in place before filling the pebbles. In order to prevent the deformation of the stainless steel screen, two adjacent stainless steel screens (including adjacent cells of the same stainless steel screen) ) The height difference of the rockfill should not be greater than 35 cm;

Preparation work before installation of the stainless steel screen, the stainless steel screen should be properly trimmed the bank slope and ground before installation, and the original shape of the bank slope should be maintained as much as possible, but there should be no obvious bulges and depressions;

When filling pebbles in the stainless steel screen, the exposed surface should be pebbles with a particle size of not less than 10 cm, and artificially laid out to obtain a beautiful surface and prevent water from washing away the pebbles from the mesh. The height of the super-filled stone should be 2.5～3 cm in order to leave room for subsidence;